ATI fglrx proprietary driver problem

Hi,

I have a Fujitsu Siemens Amilo M 7424 centrino notebook with a ATI Mobility Radeon 9700 SE.

Although - as ATI says - this card is supported by the latest version (8.8.25) of the proprietary linux driver, I always get the following error when loading the module:

plimo-laptop:~# modprobe fglrx bane: Error inserting fglrx (-lib-modules-2.6.10-misc-fglrx.ko): No such device plimo-laptop:~#

The output of lspci is the following:

0000:01:00.0 VGA compatible controller: ATI Technologies Inc RV350 Mobility Radeon 9600 M10 (prog-if 00 VGA) Subsystem: Unknown device 1734:1080 Control: I-O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B- Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium Interrupt: pin A routed to IRQ 11 Region 0: Memory at d0000000 (32-bit, prefetchable) size=128M Region 1: I-O ports at b000 size=256 Region 2: Memory at ffcf0000 (32-bit, non-prefetchable) size=64K Expansion ROM at ffcc0000 disabled size=128K Capabilities: 58 AGP version 2.0 Status: RQ=80 Iso- ArqSz=0 Cal=0 SBA+ ITACoh- GART64- HTrans- 64bit- FW+ AGP3- Rate=x1,x2,x4 Command: RQ=1 ArqSz=0 Cal=0 SBA+ AGP- GART64- 64bit- Capabilities: 50 Power Management version 2 Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=0 PME-

Any ideas, why this driver does not work?

Bjšrn.