eagle usb connexion
spyk a Žcrit :
and this is the eaglediag -masc :
Diagnostic (1.23 2005-07-02) driver eagle-usb 20060604142551 # System Information Linux localhost 2.6.12-12mdk #1 Fri Sep 9 18:15:22 CEST 2005 i686 Intel(R) Pentium(R) 4 CPU 1.70GHz unknown GNU-Linux Mandriva Linux release 2006.0 (Official) for i586 (4.0.1-5mdk for Mandriva Linux release 2006.0)) #1 Fri Sep 9 18:15:22 CEST 2005 gcc version 4.0.1 (4.0.1-5mdk for Mandriva Linux release 2006.0) # Dependances le paquetage kernel-source n'est pas installŽ kernel-source-2.6-2.6.12-12mdk ppp-2.4.3-9mdk dhcp-client-3.0.3-3mdk dhcpcd-1.3.22pl4-4mdk # Kernel config : usb modules pppasync 8704 1 crcccitt 1632 1 pppasync pppgeneric 24788 5 pppasync slhc 5984 1 pppgeneric eagleusb 122660 0 uhcihcd 29136 0 ehcihcd 29192 0 ohcihcd 19140 0 usbcore 108348 5 eagleusb,uhcihcd,ehcihcd,ohcihcd # module loaded ? OK # modem operational ? OK eagle-usb status display ------------------------------------------------------------- Driver version 2.3.3 Chipset: Eagle0 Vendor ID : 0x1110 Product ID : 0x9031 Rev: 0x200b USB Bus : 004 USB Device : 002 Dbg mask: 0x0 Ethernet Interface : eth0 MAC: 00:60:4c:c3:a8:c7 Tx Rate 64 Rx Rate 128 FEC 0 Margin 36 Atten 29 dB VID-CPE 0 VID-CO 28 HEC 0 VPI 0 VCI 35 Delin GOOD Cells Tx 31 Cells Rx 0 Pkts Tx 15 Pkts Rx 0 OAM 0 Bad VPI 0 Bad CRC 0 Oversiz. 0
Modem is operational
Which one is the root drive? For example I have: ~# catetc-fstab #etc-fstab for slackware on stinkpad -- 2006-05-05 #dev-hda5 swap swap defaults...
# Config vpi-vci-encapsulation-isp : 23 1 (pppoe) DZ01 # pppd launched ? OK # Service for connection OK #etc-resolv.conf should contain the DNS nameserver 81.22.90.29 nameserver 82.101.136.29 # nameserver 81.101.136.29 # nameserver 81.22.60.29
# ppp temp entry eth0 Link encap:Ethernet HWaddr 00:60:4C:C3:A8:C7 adr inet6: fe80::260:4cff:fec3:a8c7-64 Scope:Lien UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:15 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 lg file transmission:1000
lo Link encap:Boucle locale LOOPBACK MTU:16436 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 lg file transmission:0
ppp0 Link encap:Protocole Point-ˆ-Point POINTOPOINT NOARP MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 lg file transmission:3
sit0 Link encap:IPv6-dans-IPv4 NOARP MTU:1480 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 lg file transmission:0
On 9 Jun 2006 06:45:27 -0700, heavytull staggered into the Black Sun and said: Whoa. You *never* write to the raw device node of a mounted filesystem unless you know exactly what you're doing. If...
That's not a bad solution, but you might consider an alternative: give your client to call in to dyndns.org whenever the IP address changes. I use ipcheck, but there are lots of update clients...
Table de routage IP du noyau Destination Pbutterelle Genmask Indic Metric Ref Use Iface # ping IP ? KO # test DNS resolution ? KO
Linux groups from Newsgroups